Hekate 6.0.3 + Nyx 1.5.3

6 avril 2023 badablek Atmosphère, ctcaer, hack, hekate, payload, switch

L’excellent payload/bootloader Hekate, développé par CTCaer, vient de subir une mise à jour. Celle-ci fait la part belle à Linux cette fois-ci, avec notamment l’ajout du mode DDR200 pour les microSD compatibles (ce qui devrait donner un bon coup de boost aux chargements de l’OS) et le support des RAM Samsung avec un timing de 2133MHz. Quelques petits bugs ont aussi été corrigés, principalement pour nettoyer la crasse que certains (mauvais) loaders laissent derrière eux…

hekate 6.0.3 and Nyx 1.5.3 are now released!

– Added base support for SD UHS DDR200 for L4T
– 2019 Samsung ram can now run on 2133MHz with super tight timings on L4T
– Mitigated an issue with some bad loaders
– Various fixes

Check release log for more!https://t.co/LX5oGSEs4A

— CTCaer (@CTCaer) April 6, 2023

↓ Nouveautés / Corrections (cliquer pour voir) ↓'

hekate v6.0.3 changes

A mitigation was added for bad chainloaders that leave sd gpios in a bad state
L4T: Now some 2019 T210B01 Samsung ram chips can be overclocked to 2133 MHz for Linux/Android.
L4T: Added a mandatory change for supporting SD UHS DDR200 bus speed for Linux/Adnroid.
Fixed an edge case where if hekate was run and the rtc alarm was fired after, booting to HOS would power off the device.
Since in that case the Switch was awakened via Power or USB, all flags are now cleared during Auto HOS Power off checks.
Various fixes and improvements

Nyx v1.5.3 Changes

SD Card/eMMC benchmark now stalls less between each read, in order to stress the cards more.
Various fixes and improvements

Hekate CTCaer Mod/Nyx 6.2.1/1.6.3 (857.03 KB)

Télécharger

GitHub